Mold type repair direction1. The raw edge is divided into pl edging, broken burrs, and burrs1.pl The cause of the burr is that the strength of the mold is insufficient. On the basis of the ok method, it is necessary to confirm: The height, quantity and positio···

The basic knowledge of the mold is to tell the basic composition of the mold, the influence of the shape on the product, and the introduction of the mold model.1. The basic composition of the mold(1) Front mold (master mold) (fixed mold), (2) rear mold (male m···

The basic knowledge of the mold is to tell the basic composition of the mold, the influence of the shape on the product, and the introduction of the mold model.1. The basic composition of the mold(1) Front mold (master mold) (fixed mold), (2) rear mold (male m···

Plastic injection molding provides tight tolerances and repeatability and is ideal for high volume production of plastic molded parts. Injection molded plastic parts can be manufactured using a wide range of thermoplastic polymers, resins and elastomers, makin···

The process cycle for injection molding is very short, typically between 2 seconds and 2 minutes, and consists of the following stages:Clamping - Prior to the injection of the material into the mold, the two halves of the mold must first be securely closed by ···

Injection molmatchding is the most commonly used manufacturing process for the fabrication of plastic parts. A wide variety of products are manufactured using injection molding, which vary greatly in their size, complexity, and application. The injection moldi···